DEZOBOND S
Protective mortar and anti-silicate acid
Anti-acid mortar for installation and bonding of anti-acid tiles and bricks based on modified potassium silicate and special hardener for this mortar for installation and bonding of anti-acid tiles and bricks and in cases where we are faced with spilling of strong acidic liquids and washing the tiled surface It is used with water. This mortar can also be used exposed and without tiles.
Application
• Installation and bonding of acid-proof tiles or bricks on floor and wall surfaces
•Channels
• Metal or concrete tanks
• Bricklaying of industrial chimneys
• Applying a protective layer on the floors adjacent to corrosive environments (with a thickness of 5 mm)
•Technical Specifications
• Resistance to strong acids (except for hydrofluoric acid)
• Resistant in neutral environments (washing with water)
• Resistant to the game environment
• UV resistant
• Resistance in hot environments up to 900 degrees Celsius
• Resistant to light traffic
• Specific weight: 2 grams per square centimeter
• Compressive strength: 30 N/mm2
• Bending strength: 13 N/mm2
Permeability percentage against water: 10%
• Duration of use of mortar after mixing two components: 30-60 minutes
Instructions
1- Mixing ratio of powder to liquid, 1:1
2- According to the given mixing ratio, first mix component B (liquid) until it becomes homogenous. Then add the powder to the liquid while mixing until it is completely uniform.
Note: Before use and application, the working surface must be well cleaned, free of dust, weak points and oil. Damaged areas should be repaired.
Time required for complete hardening
This mortar hardens after 2-3 days and reaches full hardness after 8 days. After that, the entire work surface is washed with 98% sulfuric acid, thus the mortar will reach the highest level of resistance.
Maintenance
Powder: It can be stored indefinitely if stored in a covered warehouse.
Liquid: Store at a temperature above +5 degrees Celsius and without freezing.